Remove/install rear seat belts · ar9140p0681lc · Mercedes-Benz WIS

AR91.40-P-0681LC

Remove/install rear seat belts

19.09.2014

MODEL

217.3

Shown on right side of vehicle

1	Seat belt
2	Seat belt retractor
3	Screw
4	Electrical connector
5	Screw

P91.40-3458-06

 Danger !	Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units.	Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply.	AS91.00-Z-0001-01A
 Danger !	Risk of injury. Injury may result when the tension in the spring in the automatic belt retractor is released.	Never disassemble automatic belt retractors.	AS91.00-Z-0002-01A
	Notes on performing repair, body work and welding on vehicles with airbags and RTE units		AH91.00-P-0002-01M
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Assessment of airbag and belt tensioner units in accident vehicles		AH91.00-P-0006-01B
	Legal requirements on handling and storing airbags and emergency tensioning retractor units		AH91.00-P-0004-01A
 	Remove/install
1	Remove front part of rear shelf		AR68.30-P-4581LC
2	Remove lower side paneling in rear		AR68.30-P-4780LC
3	Remove screw/bolt (3) from seat belt (1)	 Push the soundproofing (arrow a) upwards.
		 Bolt, rear belt end fitting to longitudinal member	*BA91.40-P-1009-01V
4	Push off soundproofing (arrows b, c) upwards
5	Disconnect electrical connector (4) from seat belt retractor (2)
6	Remove screw/bolt (5) from seat belt retractor (2)	 Bolt, rear seat belt retractor to rear panel	*BA91.40-P-1008-01V
7	Twist seat belt retractor (2) and remove from above	When replacing belt retractor (2)
		
		Dispose of the seat belt retractor (2) properly.
8	Install in the reverse order
9	Connect diagnostic system and check supplemental restraint system (SRS)	When replacing belt retractor (2)
			AD00.00-P-2000-04B

 Seat belts

Number	Designation		MODEL 217
BA91.40-P-1008-01V	Bolt, rear seat belt retractor to rear panel	Nm	35

 Seat belts

Number	Designation		MODEL 217
BA91.40-P-1009-01V	Bolt, rear belt end fitting to longitudinal member	Nm	35

Referenced documents

ad0000p200004b Connect STAR DIAGNOSIS and read out fault memory
ah5400p000101a Information on preventing damage to electronic components due to electrostatic discharge
ah9100p000201m Notes on performing repair, body work and welding on vehicles with airbags and RTE units
ah9100p000401a Legal requirements on handling and storing airbags and emergency tensioning retractor units
ah9100p000601b Assessment of airbag and belt tensioner units in accident vehicles
ar6830p4581lc Remove/install rear shelf
ar6830p4780lc Remove/install side paneling in rear
as9100z000101a Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units.
as9100z000201a Risk of injury. Injury may result when the tension in the spring in the automatic belt retractor is released.