AR91.30-P-0031RT | Remove/install heated seats and seat ventilation control unit | 20.6.06 |
MODEL 251
with CODE (401) Front comfort seats, incl. seat heating and seat ventilation
with CODE (443) Steering wheel heater
with CODE (872) Electrically heated left and right rear seats
P91.30-2268-06
Shown on model 251.0
1 B-pillar paneling
2 Cover
3 Bolt
4 Anchoring lug
5 Cover
6 Sliding rail cover
7 Plastic nuts
8 Intermediate bottom
9 Clip
10 Electrical connector
N25/7 HS [SIH], seat ventilation and steering wheel heater control unit
| Remove/install | ||
1 | Move front seat toward front | ||
2 | Remove rear seat | Only on left side. | |
3 | Remove B-pillar paneling (1) | Belt end fitting must not become detached. | |
4 | Unclip cover (2), unscrew bolt (3) and remove anchoring lug (4) | | |
5 | Remove cover (5) under anchoring lug (4) and sliding rail cover (6) | ||
6 | Lift up floor lining | ||
7 | Unscrew plastic nuts (7) and remove intermediate bottom (8) | Model 251.0: 4 plastic nuts | |
Model 251.1: 6 plastic nuts | |||
Detach clip (9) from intermediate bottom (8). | |||
8 | Disconnect electrical connector (10) and remove HS [SIH], seat ventilation and steering wheel heater control unit (N25/7) | The number of electrical connectors may vary depending on the equipment. | |
9 | Install in the reverse order |
Cargo retainers
Long wedge
115 589 03 59 00
Referenced documents
- ar6830p4700rt Remove/install paneling on B-pillar
- ar9112p1000rt Remove/install rear seat
- ar9112p1000rta Remove/install rear seat
- ar9112p1000rtb Remove/install rear seat