P88.60-2176-09
1 Tank recess
2 Lock (not on model 451.39/49)
3 Fuel filler flap
4 Seal
9 Hinge bracket
M14/10 Fuel filler flap CL [ZV] motor
5 Snap-release tool
6 Adhesive tape
7 Bracket
8 Electrical connector
| Remove/install | ||
Danger! | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel and risk of injury to eyes and skin caused by contact with fuel | No fire, sparks, open flames or smoking. Wear protective clothing when handling fuel. | |
1 | Mask CBS rear in rear area of tank recess (1) with suitable adhesive tape (6) | ||
2 | Open fuel filler flap (3) | ||
3 | Unscrew lock (2) from tank filler neck | Not on model 451.39/49 | |
4 | Loosen lock (2) on hinge lever (9) (arrow A) and lay down to side | Not on model 451.39/49 | |
5 | Unclip bracket (7) from tank recess (1) with clip remover (5) | Clip remover | |
6 | Close fuel filler flap (3) and remove tank recess (1) until electrical connector (8) on fuel filler flap CL motor (M14/10) is accessible | ||
7 | Disconnect electrical connector (8) from fuel filler flap CL motor (M14/10) and remove tank recess (1) | ||
8 | Unclip fuel filler flap CL motor (M14/10) from tank recess (1) and remove | When replacing tank recess (1). | |
9 | Remove fuel filler flap (3) from hinge lever (9) in direction of arrow | When replacing tank recess (1). | |
10 | Remove hinge lever (9) from tank recess (1) and remove | When replacing tank recess (1). | |
11 | Install in the reverse order |
Clip remover
452 589 01 63 00
Referenced documents
- as4700z000101a Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel.