1 | Engine hood |
2 | Hood support |
3 | Retainer |
4 | Spring |
5 | Hinge |
6 | Nut |
D88.40-1128-06
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove | ||
1 | Remove retainer (3) and hook support (2) with spring (4) from guide on engine hood (1) | Support engine hood (1). | |
Pay attention to installation position of spring (4). | |||
2 | Unscrew nut (6) on left and right hinge (5) and remove engine hood (1) | ||
| Install | ||
3 | Install engine hood (1) on both hinges (5) | Tighten nuts (6) only to stop, nuts (6) are tighten after adjusting engine hood (1). | |
4 | Install spring (4), insert hood support (2) into guide on engine hood (1) and mount new retainer (3) | ||
5 | Adjust engine hood (1) | ||
6 | Grease both hinges (5) |
Referenced documents
- ar8840d3020f Adjust engine hood
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.