ar8370d5758a

Removing and installing glow plug

Type ar · topic 83.70 · version 0104 · 1998-07-31

Applies to: MODEL 902.32# /42#, 903.32# /42#, 904.32# /42# ## up to 753730 up to 31.10.97 with CODE (H11) Hot air auxiliary heater Heater designation D1L-C MODEL 903.02# ## up to 753730 up to 31.10.97 with CODE (H11) Hot air auxiliary heater Heater designation B1L-C

Where it sits

Function group 3 Body › 83 Climate control › 83.70 Auxiliary/supplementary heater — Series 902 (models 32*, 42*) · Series 903 (models 02*, 32*, 42*) · Series 904 (models 32*, 42*)

EinPAS 39 Heating/ventilation/cooling › 39.25 Stationary heater/auxiliary heater › 39.25.30 Heater — Series 902 (models 32*, 42*) · Series 903 (models 02*, 32*, 42*) · Series 904 (models 32*, 42*)

AR83.70-D-5758A

Removing and installing glow plug

4.11.96

MODEL 902.32# /42#, 903.32# /42#, 904.32# /42# ## up to 753730 up to 31.10.97 with CODE (H11) Hot air auxiliary heater
Heater designation D1L-C

MODEL 903.02# ## up to 753730 up to 31.10.97 with CODE (H11) Hot air auxiliary heater
Heater designation B1L-C

Removing and installing glow plug

D83.70-0011-06

1 Allen bolt
2 Cover
3 Gasket
4 Hex. nut
5 Cable for glow plug
6 Glow plug
7 Sealing ring
8 Glow plug screen

Removal, installation

Danger!

Fuel vapors present an explosion hazard. Combustion gases are toxic when inhaled. Heater can cause severe burns during and after operation

Do not start up or operate stationary heaters or engines with heater boosters in closed rooms or in the vicinity of service stations. Allow heater to cool off after operation and wear protective gloves.

AS83.70-Z-0002-01A

Danger!

Fuel vapors present an explosion hazard. Fuel vapors are toxic when inhaled or absorbed. Contact with fuel can cause eye and skin injury.

Fire, open lights and smoking prohibited.
Fill and store fuel only in containers intended for this purpose and marked accordingly.

Wear protective clothing when handling fuel.

AS47.00-Z-0001-01A

1

Remove heater

AR83.70-D-5302A

2

Remove cover (2) together with gasket (3)

Installation: Check gasket for damage, replace, if necessary.

3

Remove cable (5) from glow plug (6)

4

Remove glow plug (6)

5

Remove sealing ring (7)

Installation: Use new sealing ring.

6

Remove glow plug screen (8)

Installation: Version D1L-C (diesel)
Observe installation position of lug (arrow A). The bore for the glow plug vent
(arrow B) must be free.

Installation: Version B1L-C (gasoline)
Observe installation of separating joint on screen (arrow C). The bore for the glow plug vent (arrow D) must be free.

7

Install in opposite order

Referenced documents