Remove/install heater control cable

AR83.20-D-1400F

Remove/install heater control cable

04.06.2013

MODEL

909

without CODE HH9 (Regulated air conditioning (Tempmatic))

1

Heater control cable

2

Heater control adjusting lever



Remove

1

Remove cover of radio installation slot

2

Remove stowage compartment below pen holder

3

Remove covering on instrument cluster

AR68.10-D-1550F

4

Remove instrument cluster

AR54.30-D-6015F

5

Remove stowage compartment above glove compartment

AR68.10-D-1515F

6

Remove paneling of left and right A-pillar

 Unclip paneling at top and pull out upwards.

7

Remove speaker

AR82.62-D-7833F

8

Remove cover on center part of dashboard

AR68.10-D-1190F

9

Remove climate control control and operating unit

AR83.25-D-1124FB

10

Remove top part of dashboard

AR68.10-D-1020F

11

Cut repair cutout in instrument panel

AR68.10-D-1000-03F


The cutting depth should be max. 3 mm.
Otherwise the components below can be damaged.

12

Unclip heater control wire (1) at connector and detach from heater control adjustment lever (2)

Adjust

13

Attach heater control wire (1) at climate control control and operating unit

14

Attach heater control wire (1) at heater control adjustment lever (2)

15

Adjust heater control wire (1)

AR83.20-D-1400-01F



Install

16

Install upper section of dashboard

AR68.10-D-1020F


The electrical lines must not lie over the air duct when routing.
Otherwise electrical lines may be damaged.

17

Attach climate control control and operating unit

AR83.25-D-1124FB

18

Install covering on center part of dashboard

AR68.10-D-1190F

19

Install loudspeaker

AR82.62-D-7833F

20

Install paneling of left and right A-pillar

 Insert paneling in lower area and clip in at top.

21

Install stowage compartment above the glove compartment

AR68.10-D-1515F

22

Install instrument cluster

AR54.30-D-6015F

23

Install covering on instrument cluster

AR68.10-D-1550F

24

Install stowage compartment below pen holder

25

Remove cover of radio installation slot

26

Set time on instrument cluster

27

Set time on timer for auxiliary heater

MODEL 909
with CODE H12 (Auxiliary heater (warm water))
without CODE HH9 (Regulated air conditioning (Tempmatic))
MODEL 909
with CODE H86 (Chronometer with relay for independent heating)
without CODE HH9 (Regulated air conditioning (Tempmatic))
MODEL 909
with CODE HZ5 (10 kW warm water auxiliary heater with timer)
without CODE HH9 (Regulated air conditioning (Tempmatic))

28

Connect diagnostic system and perform quick test



AD00.00-D-2000-04F

 Delete DTC memory if necessary.