ar8230t6800a

Remove/install wiper motor

Type ar · topic 82.30 · version 0102 · 2006-10-31

Applies to: MODEL NMB613.355 /358 /388 /455 /485

Where it sits

Function group 3 Body › 82 Electrical system, body › 82.30 Windshield wipers — Series 613 (models 355, 358, 388, 455, 485)

EinPAS 36 Visibility › 36.30 Wiping/washing › 36.30.50 Windshield wiper system — Series 613 (models 355, 358, 388, 455, 485)

AR82.30-T-6800A

Remove/install wiper motor

5.9.00

MODEL NMB613.355 /358 /388 /455 /485

Remove/install wiper motor
Remove/install wiper motor

T82.30-0008-01

1 Wiper linkage

2 Relay lever

3 Wiper linkage

4 Lever

6 Carrier plate

5 Windshield wiper motor

7 Connector

T82.30-0009-01

Remove/Install

Danger!

Risk of injury in the form of trapping or crushing, or even severing of limbs, if caught in windshield wiper mechanism

Always remove ignition key when working on windshield wiper mechanism.

AS82.30-Z-0001-01A

1

Remove windshield wiper linkage cover

Installation: Before installing the windshield wiper linkage cover, check the function of the windshield wipers.

AR88.80-T-5100B

2

Remove wiper linkage (1) of right windshield wiper from transfer lever (2)

3

Remove wiper linkage (1, 3) of right and left windshield wipers from lever (4)

4

Remove lever (4) from shaft of windshield wiper motor (5)

Installation: To install the lever (4) the wiper arms must be in the park position at the bottom edge of the windshield. The lever (4) must be put onto the shaft of the windshield wiper motor (5) in a horizontal position.

5

Remove supporting plate (6) with windshield wiper motor (5) from front end.

Installation: Replace rubber seal.

*BR00.45-Z-1052-01A

6

Disconnect plug (7) of connecting cable from windshield wiper motor (5)

7

Detach windshield wiper motor (5) from the carrier plate (6)

Installation: A new windshield wiper motor (5) must be moved into the park position before installation.

To do this, connect plug (7) of the connecting cable to the new windshield wiper motor (5), switch on ignition and switch the windshield wipers on and off again.

8

Install in the reverse order

9

Check for proper function

Windshield wipers, windshield washer system - operational inspection

AP82.35-T-8252A

Repair materials

Number

Designation

Order number

BR00.45-Z-1052-01A

Redusoft DI 150 foam tape,
Dimensions: 12 mm x 5.3 mm, light gray, self-adhesive on one side

Hanno-Werk Gmbh & Co.KG
Hanno-Ring 5
30880 Laatzen
Germany
Tel.+49 5102 7000-0
Fax +49 5102 7000-102
www.hanno.com

Referenced documents