P72.10-3254-09
1 Door frame seal
2 Window frame paneling
3 Mirror triangle cover
4 Spacer strips
| Removing | ||
Danger! | Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof | Keep body parts and limbs well clear of moving parts. | |
1 | Wind crank window fully down | ||
2 | Switch off ignition and remove the transmitter key from the EIS [EZS] control unit | On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m). | |
3 | Remove mirror triangle cover (3) from front door | ||
Assembly wedge | |||
4 | Loosen window frame paneling (2) from window frame and door frame seal (1) | Do not damage paint. | |
Only loosen window frame trim (2), do not completely remove it. | |||
Assembly wedge | |||
5 | Completely remove door frame seal (1) from front door | ||
| Clean | ||
6 | Remove sealing and glue residues from front door using eraser disc | Dia. 100 mm removal disk with mounting shaft | |
Drill | |||
7 | Use suitable scraper to remove sealing and adhesive residue on front door, if necessary use solvent to remove still remaining residue | At points on front door which are not accessible using an eraser disc | |
8 | Clean bonding surface on front door | Bonding surface must be free of grease and dust. | |
Cleaner | |||
| Install | ||
9 | Glue door frame seal (1) onto front door | Start at upper left corner (arrow), then glue on in one direction to the end. | |
In the upper area of the door, the spacer strip (4) must make contact with the window frame, in the lower area on the profile bend of the door skin. | |||
The adhesive line can still be corrected as long as the door frame seal (1) is not yet firmly pressed on. | |||
10 | Press on door frame seal (1) using a roller, detach spacer strip (4) | Roller | |
11 | Clip window frame trim (2) onto window frame and rubber seal | Do not damage door frame seal (1) and paintwork. | |
The edges of the window frame trim (2) must be slipped between the bonding base and the seal strip of the door frame seal (1). | |||
Assembly wedge | |||
| Checking | ||
12 | Check closing behavior of front door by opening and closing it several times, if necessary correct adhesive line of door frame seal (1) | ||
| Install | ||
13 | Install mirror triangle cover (3) of front door | ||
14 | Switch on ignition, close crank window | ||
| Clean | ||
15 | Remove dirt from front door and in entrance area |
168 589 05 63 00
Roller
Mounting wedge
110 589 03 59 00
Repair materials
Number | Designation | Order number |
BR00.45-Z-1025-04A | Cleaner | A 005 989 19 71 |
Referenced documents
- ar7210p3001rt Remove/install mirror triangle cover on front door
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.