Remove/install front partition wall

AR68.74-D-0700A

Remove/install front partition wall

19.02.2019

Model

906.6/7

with code D50 (Full-length partition)

Model

906.6/7

with code D51 (Entire partition with 1 window)

Model

906.6/7

with code D53 (Full-length partition with 1 sliding window)

Shown on model 906.6 with code D51 (Full-width partition wall with 1 window) except code V07 (Rear panel trim)

1

Partition wall

2

Floor covering

3

Bolts

Shown on model 906.6 with code T19 (Sliding door, left), code T16 (Sliding door, right) and code D05 (Super-high roof)

1

Partition wall

5

Tie-down eye

7

Bolts

4

Pushbutton

6

Bolts

8

Bolts

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

 

Remove/install

1

Move driver's seat forward and to topmost position.

2.1

Move front passenger seat forward and to topmost position.

Model 906.6/7 except code S23 (Two-seater front passenger seat)

2.2

Remove front passenger bench seat.

Model 906.6/7 with code S23 (Two-seater front passenger seat)

AR91.10-D-1035A

3

Lift floor covering (2) in cab rear at partition (1).

4

Remove screws (3) at bottom at partition (1).

5

Remove left and/or right push button switch (4) for electric sliding door.

Model 906.6/7 with code T55 (Electrical actuation for right sliding door) and/or code T56 (Electrical actuation for left sliding door)

AR54.25-D-0009A

6

Remove trim from sliding door entrance step module.

AR68.30-D-0018A

7

Remove tie-down eyes (5) in the load compartment from the B-pillars.

 Screw, tie-down eye to B-pillar

*BA68.50-N-1001-03A

8

Remove screws (6, 7, 8).

 Installation: Position screws (3, 6, 7, 8) and then tighten screws (6, 7, 8).

 The number of screws varies (6, 7, 8) depending on the design.

9

Release partition (1) from vehicle.

 Installation: Align partition (1).

10

Guide left and/or right electric line of push button switch (4) for electric sliding door out of partition (1).

Model 906.6/7 with code T55 (Electrical actuation for right sliding door) and/or code T56 (Electrical actuation for left sliding door)

 Installation: Observe edge guard of electric line.

11

Remove partition (1) from vehicle.


Carefully remove partition (1) from vehicle.
Partition (1), body and/or adjacent detachable parts can otherwise be damaged.

 Helper required.

12

Install in the reverse order

13

Remove detachable parts from the partition (1).

If new partition (1) is installed.

 The detachable parts vary depending on the design and equipment.

 Cargo retainers

Number

Designation

Model 906

BA68.50-N-1001-03A

Screw, tie-down eye to B-pillar

Nm

18