W54.20-1001-06
1 Central electrical system
2 Screws
S21 Connector for left cab release switch
S22 Connector for right cab release switch
9 Rear wall paneling
11 Retainer on roof frame
12 Retainer on C-pillar
W63.20-1093-03
W68.50-1002-10
21 Mounting frame for roof stowage compartments
| Removal, installation | ||
Danger! | Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices | No fire, sparks, open flames or smoking. Wear acid-resistant gloves and clothing and safety glasses with side guards. Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground. Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers. | |
1 | Disconnect ground lead from battery | Ensure that the ground lead and negative pole of battery do not make unintentional contact. | |
| Notes on battery | All models | |
2 | Remove headliner | ||
3 | Remove passenger bench seat | ||
4 | Remove cup holder | The cup holder is fastened to the engine tunnel with Velcro strips. | |
5 | Remove driver's seat | ||
6 | Remove cover from central electrical system | See Operating Instructions. | |
7 | Disconnect connectors (S20, S21) from base module (1) | ||
8 | Unscrew screws (2) for central electrical system (1) from wheelhouse on driver's side and slide central electrical system (1) toward front | Secure central electrical system against falling down. | |
9 | Position central electrical system on cab floor | ||
10 | Remove left and right retainers (12) for side paneling from C-pillar | ||
11 | Remove rear retainer (11) for side paneling from roof frame on left and right | ||
12 | Remove belt reel for passenger seat bench from rear wall | ||
13 | Remove mounting frame (21) for roof stowage compartments | Installation: Replace porous and damaged rubber expanding anchors. Do not tighten screws too tight. | |
14 | Unscrew screws from rear wall paneling and remove rear wall paneling | ||
15 | Install in opposite order |
Referenced documents
- ah5410p000101a Notes on battery
- ah5410p000101a
- ar6830w4300c Remove/install headliner
- ar9110w1030a Removing and installing (front) passenger bench seat
- ar9110w3430b Seat, removal and installation on support bracket
- ar9140w3000a Removing and installing seat belts on passenger bench seat
- as5410z000101a Risk of fire/risk of explosion due to short circuit and escaping oxyhydrogen gas. Risk of (burn) injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte/mist, short circuit and arcing. Risk of