Remove/install paneling on A-pillar

AR68.30-S-4050C

Remove/install paneling on A-pillar

14.8.15

Model

415

Shown on left side of vehicle with code J67 (Anti-theft alarm system)

1

Cover

2

Frame seal

3

Anti-theft alarm system (ATA) ultrasonic sensor



Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A



Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S



Remove

1

Detach sealing frame (2) in working area

2.1

Pull out paneling (1) starting at top upward and remove

Model 415
except code J67 (Anti-theft alarm system)

 Mounting wedge

*110589035900

2.2

Unclip paneling (1) starting at top, pull out upward and lay down to side

Model 415
with code J67 (Anti-theft alarm system)

 Mounting wedge

*110589035900

3

Disconnect electrical connector on ATA ultrasonic sensor (3), expose electrical wiring harness and remove paneling (1)

Model 415
with code J67 (Anti-theft alarm system)

AR80.50-S-9850C

4

Remove ATA ultrasonic sensor (3) together with retaining plate from paneling (1)

When replacing paneling (1).

Model 415
with code J67 (Anti-theft alarm system)

AR80.50-S-9850C



Install

5

Prepare new paneling (1) for installation

When replacing paneling (1).

Model 415
with code J67 (Anti-theft alarm system)

AR68.30-S-4050-02C

6

Route electrical connector on ATA ultrasonic sensor (3) and connect electrical connector

Model 415
with code J67 (Anti-theft alarm system)

AR80.50-S-9850C

7

Position paneling (1) and install

 Check for correct seating.

8

Install sealing frame (2)

 Check for correct seating.



Check

9

Check ATA for proper function

 Pay attention to the operating instructions.