ar6830p4320lwr

Removing and installing soft top paneling

Type ar · topic 68.30 · version 0101 · 2017-06-02

Applies to: Model 205.4 Model 238.4

Where it sits

Function group 3 Body › 68 Interior equipment › 68.30 Coverings, trim — Series 205 (models 4**) · Series 238 (models 4**)

EinPAS 37 Interior equipment › 37.45 Trim › 37.45.32 Roof lining — Series 205 (models 4**) · Series 238 (models 4**)

AR68.30-P-4320LWR

Removing and installing soft top paneling

04.05.2017

Model

205.4

Model

238.4

Removing and installing soft top paneling

1

Cover

2

Seal

3

Seal

P68.30-3910-04

Warning

Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities.

No parts of the body or limbs should be within the operating area of mechanical components when moving components.

AS00.00-Z-0009-01A

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Warning

Risk of injury when performing check and repair work in area of roll bar

Keep body parts out of the area where the roll bars extend.
Do not use the cover in the area of the roll bar as a storage place for objects.

AS91.00-Z-0003-01LCA

Remove/install

1

Move soft top to repair position R4

AR77.30-P-1030LWR

Installation: Completely close soft top.

2

Cover both rear fenders

3

Unclip paneling (1) and remove

Installation: Ensure that front seal (2) and outer seals (3) are seated properly on paneling (1).

4

Install in the reverse order

Referenced documents