P68.30-2413-09
P68.30-2414-06
P68.30-2415-01
P68.30-2416-01
| Remove/install | ||
1 | Open sliding/tilting roof | Electric tilting/sliding roof (Code 414a). | |
2 | Remove inside rearview mirror | ||
3 | Remove overhead control panel control module | ||
4 | Remove left sun visor | ||
5 | Detach edge guard from left, front door cutout | Only in roof area, as well as at A-pillar and B-pillar. | |
6 | Remove paneling from left A-pillar | ||
7 | Remove paneling from left B-pillar | Do not remove belt end fitting. | |
8 | Detach edge guard from left, rear door cutout | Only in roof area, as well as at B-pillar and C-pillar. | |
9 | Remove paneling on left C-pillar | Do not remove belt end fitting. | |
10 | Remove left, rear handle | ||
11 | Unhook clip (2) from headliner (1) at left rear | ||
12 | Detach left plastic bearing (3) of headliner (1) | Installation: Plastic bearing (3) must audibly latch. | |
13 | Remove rear dome lamp | ||
14 | Unhook clip (4) in dome lamp cutout | ||
15 | Detach edge guard from right, rear door cutout | Only in roof area, as well as at B-pillar and C-pillar. | |
16 | Remove trim on right-hand C-pillar | Do not remove belt end fitting. | |
17 | Remove right, rear handle | ||
18 | Unhook clip (2) from headliner (1) at right rear | ||
19 | Detach right plastic bearing (3) of headliner (1) | Installation: Plastic bearing (3) must audibly latch. | |
20 | Detach edge guard from right, front door cutout | Only in roof area, as well as at A-pillar and B-pillar. | |
21 | Remove paneling from right B-pillar | Do not remove belt end fitting. | |
22 | Remove paneling on right A-pillar | ||
23 | Remove right sun visor | ||
24 | Detach rail (5) of tilting/sliding roof paneling upward | Electric tilting/sliding roof (Code 414a). | |
25 | Detach headliner (1) from tilting/sliding roof frame | ||
26 | Fold down backrests of front seats | ||
27 | Position shift lever toward rear | ||
28 | Cover center console and tape with adhesive tape (6) | In order to prevent damage. | |
29 | Attach weatherstrip (7) in right door cutout | In order to prevent damage. | |
30 | Detach headliner (1) and slide it forward | Installation: Attach clips (8) and align headliner. | |
31 | Remove headliner (1) for passenger door | Second mechanic required. | |
Deformation in the areas marked (arrows) is not critical and is regarded as normal. When handled correctly, there will be no permanent deformation. | |||
32 | Install in the reverse order |
Referenced documents
- ar6830p4050f Removing and installing paneling on A-pillar
- ar6830p4490fc Remove/install trim at C-pillar
- ar6830p4700f Remove/install paneling on B-pillar
- ar6840p0001f Removing and installing interior mirror
- ar8220p0113f Removing and installing rear dome lamp
- ar8220p1000k Removing and installing overhead control panel control module