ar6830p4490fc

Remove/install trim at C-pillar

Type ar · topic 68.30 · version 0101 · 2009-12-08

Applies to: MODEL 210.0## ## as of 111291

Where it sits

Function group 3 Body › 68 Interior equipment › 68.30 Coverings, trim — Series 210 (models 0**)

EinPAS 37 Interior equipment › 37.45 Trim › 37.45.30 Vehicle interior/passenger compartment trim — Series 210 (models 0**)

AR68.30-P-4490FC

Remove/install trim at C-pillar

25.11.09

MODEL 210.0## ## as of 111291

Remove/install trim at C-pillar

P68.30-2255-09

1 Trim

2 Mount

5 Screw

6 Belt end fitting

3 Clips

4 Tabs

Removing

1

Remove rear seat cushion

AR91.12-P-1700F

2

Remove bolt (5) from belt end fitting (6)

3

Unclip mount (2).

Mount is located 16 cm below upper edge of paneling.

*115589035900

4

Remove paneling (1) in direction of arrow

Pull paneling parallel to paneling contour out of mount upward toward front at angle.

Reach into belt guide to pull out.

5

Guide belt strap through opening in paneling (1).

6

Remove clips remaining on vehicle

For this purpose turn clips (3) 90°.

Install

7

Insert clips (3) into paneling (1)

8

Guide belt strap through opening in paneling (1).

Belt strap should not be twisted.

9

Insert paneling (1) into tabs (4)

10

Fasten paneling

Press firmly in area of mount (2) and clips (3)

11

Fasten belt end fitting (6)

*BA91.40-P-1001-01A

12

Install rear seat cushion

AR91.12-P-1700F

Seat belts/emergency tensioning retractors

Number

Designation

Model
202, 208.3

Model
210

BA91.40-P-1001-01A

Screw on belt end fitting

Nm

35

35

Remove/install trim at C-pillar

Special tools

115 589 03 59 00

Long wedge

Referenced documents