1 | Edge guard |
2 | Paneling below air vent |
3 | Cover |
4 | Hood unlocking |
5 | Expansion rivet |
7 | Cover on entry |
8 | Cover |
9 | Floor covering |
10 | Screw |
D68.30-2481-06
4 | Hood unlocking |
11 | Bolts |
D68.30-2465-06
8 | Cover |
12 | Lock |
X11 | Diagnostic connector (16-pin) |
D68.30-2480-12
| Notes on carrying out repair work in the vehicle interior | ||
| Remove/install | ||
1 | Loose edge guard (1) in area of paneling (8) | Installation: Ensure that the edge guard (1) is properly seated. | |
2 | Remove paneling below air vent (2) | ||
3 | Remove cover (3) | ||
4 | Unscrew bolts (11) from engine hood release (4) | ||
5 | Remove cover from entry (7) | ||
6 | Fold floor covering (9) to side | ||
7 | Remove screw/bolt (10) | ||
8 | Remove expansion rivet (5) | Clip remover | |
9 | Remove paneling (8) until lock (12) is accessible on 16-pin diagnostic connector (X11) | ||
10 | Move lock (12) in direction of arrow and remove electrical connector from 16-pin diagnostic connector (X11) | ||
11 | Install in the reverse order |
452 589 01 63 00
Clip remover
Referenced documents
- ah6800n000101s Notes on carrying out repair work in the vehicle interior