ar6420d100001ts

Separate outer rear center section

Type ar · topic 64.20 · version 0100 · 2017-11-28

Applies to: Model 907.6/7, 910.6

Where it sits

Function group 3 Body › 64 Rear wall and rear end › 64.20 Rear end — Series 907 (models 6**, 7**) · Series 910 (models 6**)

EinPAS 35 Body/frame/detachable parts › 35.31 Rear panel/rear end › 35.31.30 Rear panel/rear end — Series 907 (models 6**, 7**) · Series 910 (models 6**)

AR64.20-D-1000-01TS

Separate outer rear center section

Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Model

907.6/7, 910.6

Repair materials

Number

Designation

Order number

BR00.45-Z-1056-07A

1K-zinc dust paint

A 000 986 28 00

The following operation steps are shown on model 907.733 with code D03 (Roof and rear-end doors, high version).

Separate outer rear center section

1

Expose weld seams on outer rear-end center section (1) (areas A and B).



2

Cut weld seams on outer rear-end center section (1) (areas A and B).


D64.20-0089-06

Separate outer rear center section

D64.20-0090-08

3

Expose spot welds on outer rear-end center section (1) (areas C and D).

4

Cut off spot welds on outer rear-end center section (1) (areas C and D).

5

Remove damaged rear center section outer section (1).

Separate outer rear center section

6

Sand down mating surfaces to bare metal in cross-hatched areas .


Sand down spot weld flanges to bare metal on both sides.



7

Remove shavings and milling chips.



8

Zinc dust paint to insides of spot weld flanges.


D64.20-0084-05

Referenced documents