The following operation steps are shown on the left side of the vehicle. This must be similarly performed for damage to the right side of the vehicle.
The superordinate service document as well as the safety information in the service document must be observed.
1 | Mark separating points on rear fender (1) and separate (areas H). |
Transfer separation points from vehicle. |
P63.50-A084-06
P63.50-A085-08
2 | Grind mating surfaces on rear fender (1) down to bare metal in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
3 | Drill through spot weld on lock striker bracket with 6.5 mm bit (area J). |
4 | Remove grinding dust and drill chips. |
5 | Apply zinc dust paint to insides of spot weld flanges. |
Do not coat bonding surface with zinc dust paint (area I). |
Observe pretreatment of bonding surfaces. |