251 589 06 23 00
Cutting template
Set of cutting templates
Spot weld milling cutter
201 589 00 51 00
251 589 11 23 00
Commercially available tools
Number | Designation | |
WH58.30-Z-1002-01A | Ball cutter, dia. 12 mm | |
WH58.30-Z-1006-01A | Vario Drill WS 91 spot weld removing tool | |
WH58.30-Z-1001-03A | Round wire brush, braided, dia. 70 mm | |
WH58.30-Z-1022-04A | Cutting disk, dia. 50 mm, 80 m/s (max. 30,600 rpm) | |
WH58.30-Z-1004-20A | Hot-air gun |
Workshop equipment
WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
WE58.40-Z-1002-03A | Straight grinder (electric/pneumatic) |
WE58.40-Z-1004-03A | Body saw (electric/pneumatic) |
P63.50-3395-06
1 Mark separation points in areas A to C and cut.
Use set of cutting templates and cutting template . Cut only through one layer.
2 Expose spot welds in areas D to F and cut out .
Shown on model 251 without panoramic glass roof with top sliding roof, code 413 and without power glass tilting/sliding roof, code 414
P63.50-3396-06
3 Expose spot welds in areas G to I and cut out
Cut out spot welds in area I from inside
Shown on model 251 without panoramic glass roof with top sliding roof, code 413 and without power glass tilting/sliding roof, code 414
P63.50-3397-09
Shown on model 251 without panoramic glass roof with top sliding roof, code 413 and without power glass tilting/sliding roof, code 414
4 Expose spot welds in areas J to O and cut out .
5 Heat rear fender (1) in area of inner foaming effect (arrows) with heat gun.
6 Remove rear fender.