164 589 09 23 00
Spot weld milling cutter
Cutting template
Set of cutting templates
164 589 04 23 00
201 589 00 51 00
Commercially available tools
Number | Designation | |
WH58.30-Z-1006-01A | Vario Drill WS 91 spot weld removing tool | |
WH58.30-Z-1001-03A | Round wire brush, braided, dia. 70 mm | |
WH58.30-Z-1022-04A | Cutting disk, dia. 50 mm, 80 m/s (max. 30,600 rpm) | |
WH58.30-Z-1004-20A | Hot-air gun |
Workshop equipment
WE58.40-Z-1001-03A | Drill (electric/pneumatic) |
WE58.40-Z-1002-03A | Straight grinder (electric/pneumatic) |
WE58.40-Z-1004-03A | Body saw (electric/pneumatic) |
P63.50-3199-09
1 Mark separation points (areas A to C) and cut.
Use set of cutting templates and cutting template . Cut only through one layer.
2 Expose spot welds (areas D to N).
Expose spot welds (area I) from inside.
3 Cut out spot welds (areas D to N) .
Cut out spot welds (area I) from inside.
P63.50-3200-11
4 Warm up rear fender (1) with heat gun (areas O and P) to loosen foam in this area.
Warming up is required, otherwise foam can tear off the rear fender when removing.
5 Carefully remove rear fender
Remove rear fender only in warmed up state. The foam should remain on the body.