Install outer rear wheel well

 The following operation steps are shown on model 207.3.

1 Install outer rear wheel well (1), rear fender, trunk lid, left rear lamp unit (E3) or right rear lamp unit (E4 ) and rubber seal and fit.

2 Check and adjust gaps.

3 Fix outer rear wheel well (1) and rear fender in place.

4 Remove trunk lid, left rear lamp unit and right rear lamp unit and rubber seal.

 Perform following steps 5 to 10 only on model 207.3.

5 Drill 6.7 mm Ø rivet holes in outer rear wheel well (1) (area E).

6 Remove rear fender and outer rear wheel well (1).

P63.10-4836-03

P63.10-4840-06

7 Deburr rivet holes on outer rear wheel well (1) on both sides.

8 Coat insides of riveted joints with zinc dust paint.

9 Install outer rear wheel well (1), fit and fix in place.

10 Rivet outer rear wheel well (1) with Ø 6.414 Polygrip flat/round head rivet (area I).

11 Outer rear wheel well (1)  (areas F, G, G1, H and J).

 Always replace damaged foam parts which can no longer be used. New foam parts are available only from the responsible Daimler department.

 All connections are  according to construction on model 207.4

12 Clean weld joints.

13 Remove drilling chips/shavings.

14 Coat bare points with zinc dust paint.