P60.10-2013-06
| Remove/install | ||
Danger! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | |
1 | Raise vehicle at frame lifting points | Ensure that vehicle is lifted at frame and correctly supported. | |
2 | Remove wheels | Installation: Observe tightening sequence and torque. | |
3 | Remove, install front bumper | ||
4 | Loosen both rear bows from front crossmember | ||
5 | Remove, install rear bumper | ||
6 | Remove, install spare tire holder | Only with spare tire mount below car. | |
7 | Remove bracket from front bumper on outer part of crossmember | ||
8 | Remove cover panel | On left and right. | |
9 | Remove bolts from body mounts | Left and right, 10 bolts. | |
| |||
10 | Remove lower halves from body mount | On left and right | |
11 | Remove, install Celette straightening bracket set | Pay attention to the arrangement drawings enclosed with the straightening bracket set. | |
12 | Remove rubber body plugs | Only on side where Celette mounts are installed. | |
13 | Position vehicle on mounts | ||
14 | Raise one side of vehicle | Lift body carefully; ensure that body does not slip when raising | |
Maximum lifting height from frame: | |||
15 | Remove upper halves from frame mount | ||
16 | Insert spacer blocks from Celette set | ||
17 | Position body on spacer blocks | ||
18 | Repeat steps 13-16 on opposite side | ||
19 | Align body to frame | Align above frame before fastening straightening bracket set. | |
| |||
| |||
20 | Fasten vehicle on mounts | ||
21 | Install in the reverse order | Align frame before fastening body on frame. See: | |
Align body with frame | |||
|
Cab, cab mounting
163 589 00 31 00
Centering drift
Centering mount
163 589 01 31 00
Referenced documents
- ap4010p4050gh Remove/install wheels, rotate if necessary
- ar6010p1070gh Celette straightening set set-up
- ar6080p120001gh Align body with frame
- ar8820p2000gh Remove/install front bumper
- ar8820p2200gh Remove/install rear bumper
- as0000z001001a Risk of death caused by vehicle slipping or toppling off of the lifting platform.