ar4750s0100sd

Remove/install fuel filter water level sensor

Type ar · topic 47.50 · version 0203 · 2009-06-08

Applies to: ENGINES 646 in MODEL 636, 639 with CODE (KL5) Fuel filter with water separator

Where it sits

Function group 1 Engine › 47 Fuel system, powertrain energy supply › 47.50 Sender, feeler, sensors — Series 636 · Series 639 · Series 646

EinPAS 16 Fuel/power supply to engine › 16.10 Fuel supply › 16.10.12 Sensor/switch/wiring harness — Series 636 · Series 639 · Series 646

AR47.50-S-0100SD

Remove/install fuel filter water level sensor

2.6.09

ENGINES 646 in MODEL 636, 639 with CODE (KL5) Fuel filter with water separator

Remove/install fuel filter water level sensor

N47.50-2004-06

1 Fuel pipe

2 Drain pipe

3 Electrical connector

4 Bolts

5 Sealing rings

6 Fuel filter water level sensor

Remove/install

Danger!

Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running

Secure vehicle to prevent it from moving by itself.
Wear closed and snug-fitting work clothes.
Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

Danger!

Risk of explosion. Fuel may ignite and explode. Risk of injury to skin and eyes caused by fuel spraying out at high pressure.

Keep all ignition sources out of hazard area.

Do not carry out any work on systems when they are under pressure

AS07.16-Z-0001-01A

Danger!

Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel and risk of injury to eyes and skin caused by contact with fuel

No fire, sparks, open flames or smoking.
Pour fuels only into suitable and appropriately marked containers.

Wear protective clothing when handling fuel.

AS47.00-Z-0001-01A

1

Remove air filter housing

AR09.10-S-1150S

2

Remove/install fuel main filter

AP47.20-S-0780B

3

Remove bolts (4)

*BA47.50-N-1001-01A

4

Remove the fuel filter water level sensor (6)

To do this turn fuel filter water level sensor (6) through 30° clockwise and remove upwards; clean surrounding environment if necessary.

Installation: Install new sealing rings (5) and moisten with fuel.

5

Reinstall in opposite order

Checking

6

Check for leaks with engine running

Sensors

Number

Designation

Engine
646.98 in model 636, 639

BA47.50-N-1001-01A

Bolt, fuel filter water level sensor to fuel filter

Nm

2

Referenced documents