P47.10-2171-06
1 Expanding rivets
2 Air fitting
3 Wiring
4 Activated charcoal filter
5 Bolts
6 Heat protection
P47.10-2172-04
7 Bracket
8 Connector
9 Fuel tank
M3/3 Fuel pump with fuel level sensor
| Remove/install | ||
Danger! | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contact with fuel. | No fire, sparks, open flames or smoking. Wear protective clothing when handling fuel. | |
1 | Remove rear drive module | ||
2 | Drain fuel tank (9) | ||
3 | Remove tank recess | ||
4 | Unscrew nuts of the right rear wheelhouse lining | ||
5 | Remove right rear wheelhouse trim panel | ||
6 | Remove the expansion rivets (1) at the air fitting (2) | ||
7 | Remove air fitting (2) | ||
8 | Disconnect lines (3) at the activated charcoal canister (4) | Installation: Do not mix up the lines. | |
9 | Remove the bolts (5) on the fuel tank (9) | | |
10 | Remove heat protection (6) | ||
11 | Pull out bracket (7) at fuel tank (9) | ||
12 | Detach connector (8) for fuel pump with fuel level sensor (M3/3) | ||
13 | Position suitable movable lifting equipment under the fuel tank (9) | ||
14 | Pull the fuel tank (9) onto the lifting equipment, secure and lower completely | If the fuel tank (9) must be replaced, see: | |
| Disposing of fuel tanks | ||
15 | Install in the reverse order | ||
| Check | ||
16 | Inspect fuel tank (9) and fuel lines for leaks |
Fuel tank
Referenced documents
- ar0100p3060rr Remove/install rear-wheel drive module
- ar4710p4001rr Draining and filling fuel tank
- ar8860p2000rr Remove/install tank recess
- as4700z000101a Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel.
- os4710p000101a Disposing of fuel tanks