ar4635p1002rr

Remove/install power steering electric motor

Type ar · topic 46.35 · version 0101 · 2007-02-12

Applies to: MODEL 452.3 /4 with CODE (V26) Power steering, EPS (FFO)

Where it sits

Function group 2 Chassis › 46 Steering › 46.35 Electrical steering — Series 452 (models 3**, 4**)

EinPAS 22 Steering › 22.15 Power steering › 22.15.44 Actuator/actuator motor/electric motor — Series 452 (models 3**, 4**)

AR46.35-P-1002RR

Remove/install power steering electric motor

9.2.07

MODEL 452.3 /4 with CODE (V26) Power steering, EPS (FFO)

Remove/install power steering electric motor

P46.35-2014-06

1 Bolts of power steering motor

2 Electrical connector

3 Sealing ring

M19 Power steering motor

Danger!

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.

Deburr repair panels.

AS00.00-Z-0017-01A

Checking

1

Read out fault memory

If necessary, eliminate any faults in the control units.

Connect STAR DIAGNOSIS and read out fault memory

AD00.00-P-2000-04RR

STAR DIAGNOSIS diagnosis system

Removing

2

Remove luggage compartment pan

3

Remove battery

AR54.10-P-0005RR

4

Unscrew bolts of power steering motor (1) on rack-and-pinion steering

5

Decontact electrical connector (2)

Unfasten cable ties.

6

Remove power steering motor (M19) from rack-and-pinion steering

There is a risk of injury when pulling out the power steering motor (M19) because the power steering motor (M19) releases suddenly when being pulled out.

Ensure that no dirt gets into the support of the power steering motor on the rack-and-pinion steering.

7

Remove sealing ring (3)

Install

8

Insert sealing ring (3)

Sealing ring (3) must be replaced.

Use a suitable lubricant to facilitate installation of the sealing ring (3).

9

Insert power steering motor (M19) into rack-and-pinion steering

Ensure scrupulous cleanliness.

Carefully insert power steering motor (M19) into the rack-and-pinion steering.

Pay attention to teething and attachment of the line bracket

10

Screw in bolts of the power steering motor (1) on the rack-and-pinion steering

*BA46.20-P-1005-01G

11

Connect electrical connector (2)

Secure with cable tie.

Route and fasten line to prevent damage and vibration noises.

12

Install battery

AR54.10-P-0005RR

13

Install luggage compartment pan

Program control unit

14

Calibrate steering angle sensor

Follow instructions in DAS.

Connect STAR DIAGNOSIS and read out fault memory

AD00.00-P-2000-04RR

STAR DIAGNOSIS diagnosis system

Steering gear

Number

Designation

Model 452.3/4

BA46.20-P-1005-01G

Bolt, electric motor to rack-and-pinion steering

Nm

16

Referenced documents