AR46.35-P-1000SM | Remove/install steering assist control unit | 11.10.05 |
MODEL 450.3 /4 (except , 450.418) with CODE (V26) Power steering, EPS (FFO)
as of WME4503001J000001
P46.35-2016-04
1 Electrical connector
2 Electrical connector
3 Ground connection
4 Nut
5 Clip
N68 Steering assist control unit
| Remove/install | ||
| Information on preventing damage to electronic components due to electrostatic discharge | All models | |
1 | Remove foot support on passenger side | ||
2 | Decontact electrical connector (1, 2) | Installation: Ensure that it is locked properly. | |
3 | Unscrew nut (4) and remove ground connection (3) | Installation: Ensure that the ground connection (3) is located between the nut (4) and the steering assist control unit (N68). | |
Installation: The line from the ground connection (3) must be routed and fixed in position so that damage and vibration noise are ruled out. | |||
4 | Remove clip (5) | Replace damaged clip (5). | |
5 | Remove steering assist control unit (N68) | Ensure that the felt strip on the back of the steering assist control unit (N68) is located in the correct position and is not damaged. The felt strips should be replaced if necessary. | |
6 | Install in the reverse order | ||
7 | Read out fault memory | Remove faults in the control units as necessary. | |
| Connect STAR DIAGNOSIS and read out fault memory | ||
STAR DIAGNOSIS diagnosis system |
Commercially available tools
Referenced documents
- ad0000p200004sm Connect STAR DIAGNOSIS and read out fault memory
- ah5400p000101a Information on preventing damage to electronic components due to electrostatic discharge
- ar6830p1340sm Remove/install footrest on passenger side