1 | Power-steering pump |
2 | Screw |
3 | Power-steering pump pressure line |
4 | Power-steering pump inlet piping |
5 | Coupling disc |
6 | O-ring |
7 | Air compressor |
B46.30-0001-12
| Remove/install | ||
1 | The access for the works and repairs execution, vary according to the body type/manufacturer | Refer to the body makers instructions. | |
2 | Remove the inlet piping (4) from the steering hydraulic pump (1) | Collect the oil that leaks. | |
Installation: In case of hose, attached by a clamp, check the clamp state and replace it if necessary. | |||
Metal piping, fastened via banjo bolt, replace the sealing washers. | |||
.Pressure piping on the hydraulic steering pump | |||
3 | Remove the pressure line (3) from the steering hydraulic pump (1) | Collect the oil that leaks. | |
Installation: Replace the sealing washers. | |||
.Suction piping on the hydraulic steering pump | |||
4 | Remove screws (2) and remove power-steering pump (1) from compressor (7) | Lubricate the O-ring (6) with engine oil. | |
Installation: Replace the O-ring (6). | |||
.Hydraulic steering pump to the compressor | |||
5 | Remove coupling disk (5) | Installation: Observe that the compressor shaft claws (7) are delayed 90 degrees in relation to the steering hydraulic pump shaft claws (1). | |
6 | Install in reverse order | ||
7 | Refill and bleed the hydraulic steering system | ||
| . |
Referenced documents
- ap4600b4611b Check and correct power steering fluid level