1 | Stringer |
2 | Self-locking nut |
3 | Intermediate steering lever holder I |
B46.00-0049-11
1 | Stringer |
2 | Self-locking nut |
3 | Intermediate steering lever holder lI |
B46.00-0050-11
| Remove | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Topical note | Notes on self-locking nuts and bolts | ||
1 | Remove the steering intermediate levers I and II (3) | ||
2 | Dismount the steering intermediate levers I and II (3) | ||
3 | Loosen and remove the self-locking nuts (2) and the holders of the steering intermediate levers | ||
| Check | ||
4 | Examine the steering intermediate lever holders I and II (3) | The bracket should be replaced when there is damage or wear, especially on the work surfaces of the seal, bearings or even the fixing thread of the castle nut. | |
| Install | ||
5 | Mount the steering intermediate levers I and II (3) | ||
Use new self-locking nuts (2). | |||
Framework screws | |||
6 | Install the steering intermediate levers I and II (3) and the steering intermediate lever holders I and II in the longitudinal member (1) |
Referenced documents
- ah0000n000101a Notes on self-locking nuts and bolts
- ar4640b0320a Remove/install steering idler arm
- ar4640b0340a Disassemble/assemble steering idler arm
- as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.