Removing and installing lock cylinder

AR46.10-P-0800A

Removing and installing lock cylinder

11.3.10



Removing

 Before removal

If lock cylinder/key is notchy or jamming, spray lock cylinder with lock cylinder grease

If it is not possible to eliminate the complaint, replace lock cylinder and key in constant use.



Grease

*BR00.45-Z-1079-06A

1

Remove steering lock, remove protective sleeve (36d) from steering lock part

AR46.10-P-0900A

2

Press in pressure stud (arrow) and pull ignition/starter switch (S2/1) with locking shaft out of the protective sleeve (36d)

 The lock cylinder (36) can only be replaced together with the protective sleeve (36d) and cap (36b). On vehicles with automatic transmission a parking lock valve (37h) is also mounted on the ignition/starter switch (S2/1).



Installing

3

Turn lock cylinder (36) to position "1" with the key (36c) and press into a new protective sleeve (36d) until the locking detent (36h) locks in position

 Since 09/94 only parts from the 4th version of the steering lock are supplied as parts (increased anti-theft protection)



Steering lock, 2nd version

BT46.10-P-0001-01A



Steering lock, 4th version

BT46.10-P-0003-01A

4

Remove key

5

Push cap (36b) onto the protective sleeve until the snap ring (36g) locks in position

 The cap (36b) is now permanently attached to the protective sleeve (36d)

6

Press the ignition/starter switch (S2/1) with locking shaft into the protective sleeve (36d) until it locks in position

Number

Designation

Order number

BR00.45-Z-1079-06A

Grease, lock cylinder, 25 ml spray can

A 001 989 26 51 10