ar4610d0200f

Remove/install clock spring contact

Type ar · topic 46.10 · version 0100 · 2013-06-21

Applies to: MODEL 909

Where it sits

Function group 2 Chassis › 46 Steering › 46.10 Steering wheel, jacket tube, steering shaft, steering lock — Series 909

EinPAS 25 On-board/network/multifunction › 25.15 Network/multifunction › 25.15.18 Switch/switch group/control panel — Series 909

AR46.10-D-0200F

Remove/install clock spring contact

28.05.2013

MODEL

909

Remove/install clock spring contact

1

Steering column trim (bottom)

2

Electrical center

3

Clock spring contact

4

Electrical connection (horn clock spring contact)

5

Electrical connection (airbag clock spring contact)

D46.10-1145-11

Remove/install

1

Remove steering wheel

AR46.10-D-0100FA

2

Remove steering column cover (1)

Installation: Note installation of lines under the steering column trim (1).

3

Loosen electrical center (2)

AR54.25-D-1382F

Connectors and electrical lines remain connected.

4

Determine and detach electrical connection (4) in electrical center (2) area

5

Determine and detach electrical connection (5) in electrical center (2) area

6

Unfasten bolts of clock spring contact (3) far enough until the clock spring contact (3) can be removed

Do not remove the bolts of the clock spring contact (3) completely.
The clock spring contact (3) bolts also serve as antirotation protection and a mounting aid.

7

Carefully remove clock spring contact (3) from steering column tube

Do not twist clock spring contact (3) and do not disassemble it.

If clock spring contact (3) is twisted.

Set the clock spring contact to center position


AR46.10-D-0200-01F

8

Install in the reverse order

Referenced documents