ar4340w1300a

Remove/install stator

Type ar · topic 43.40 · version 0201 · 2012-02-21

Applies to: MODEL 930, 934, 950, 952, 953, 954, 958 with CODE (BD9) Telma retarder Focal F 3300

Where it sits

Function group 2 Chassis › 43 Brakes - pneumatic system and auxiliary brakes › 43.40 Retarder (electric) — Series 930 · Series 934 · Series 950 · Series 952 · Series 953 · Series 954 · Series 958

EinPAS 21 Brakes/vacuum system/compressed-air system › 21.21 Retarder › 21.21.30 Housing/cap/shaft/retarder — Series 930 · Series 934 · Series 950 · Series 952 · Series 953 · Series 954 · Series 958

AR43.40-W-1300A

Remove/install stator

15.2.12

MODEL 930, 934, 950, 952, 953, 954, 958 with CODE (BD9) Telma retarder Focal F 3300

Remove/install stator

W43.40-0003-06

1 Propeller shaft

2 Rear rotor

3 Setting ring

4 Heat shield

5 Stator

6 Ground line

7 Control line

8 Adjusting panel

9 Intermediate flange

10 Stator support

Modification notes

29.3.07

Nut, rear rotor to intermediate flange

*BA43.40-N-1001-01A

Remove/install

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

1

Switch off ignition

Danger!

Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices

No fire, sparks, open flames or smoking.

Wear acid-resistant gloves and clothing and safety glasses with side guards.

Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground.

Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers.

AS54.10-Z-0001-01A

2

Disconnect ground lead from battery

Notes on battery

AH54.10-P-0001-01A

3

Detach propeller shaft (1) from propeller shaft flange on the transmission

AR41.10-W-0050A

4

Remove heat shield (4)

5

Detach ground line (6)

6

Detach control line (7)

7

Remove rear rotor (2) from intermediate flange (9)

Use commercial vehicle transmission support / plate.

*BA43.40-N-1001-01A

8

Remove adjusting disk (3)

9

Remove stator (5) from stator support (10) and remove adjusting segments (8)

Use commercial vehicle transmission support / plate.

*BA43.40-N-1004-01A

10

Install in the reverse order

11

Measure gap width, adjust if necessary

AR43.40-W-1500A

Retarder (electric)

Number

Designation

Model
930, 932, 933,
934
with Telma retarder
F3300

Model 950, 952, 953, 954, 958 with Telma retarder F3300

BA43.40-N-1001-01A

Nut, rear rotor to intermediate flange

Nm

93

93

BA43.40-N-1004-01A

Bolt, stator to stator carrier

Nm

130

130

Referenced documents