ar3530p062002pf

Pulling out and pressing in rear axle shaft in rear axle center assembly

Type ar · topic 35.30 · version 0100 · 2003-08-08

Applies to: MODEL 203.018 /065 /218 /265 /718 HA-Mittelstück 210E'

Where it sits

Function group 2 Chassis › 35 Rear axle › 35.30 Final drive, drive shafts — Series 203 (models 018, 065, 218, 265, 718)

EinPAS 17 Drivetrain/axle › 17.51 Rear axle › 17.51.51 Axle shaft/drive shaft — Series 203 (models 018, 065, 218, 265, 718)

AR35.30-P-0620-02PF

Pulling out and pressing in rear axle shaft in rear axle center assembly

Pulling out and pressing in rear axle shaft in rear axle center assembly

P35.30-2020-01

Pulling out rear axle shaft

1 Press rear axle shaft (37) out of rear axle center assembly using a suitable tool (e.g. screwdriver, assembly lever).

Do not damage the radial sealing ring when pressing out the rear axle shaft (37) so as to avoid leakage. Rear axle shafts (37) with defective joints or boots must be replaced in order to guarantee proper functioning.

Pulling out and pressing in rear axle shaft in rear axle center assembly

P35.30-2021-01

Pressing in rear axle shaft

2 Press in rear axle shaft until the locking ring (37g) can be felt to engage.

Do not damage the radial sealing ring when pressing the rear axle shaft into the rear axle center assembly so as to avoid leakage. The joint ring must be flush with the rear axle housing in order to guarantee proper functioning.

Align joint ring horizontally so that the splined profile is not tilted when inserting.