1 | Bolts (torxplus EP32) |
2 | Sleeves |
3 | Nuts |
4 | Screws (support bracket) |
5 | Triangular tensioning arm |
6 | Support bracket |
7 | Chassis frame screws |
B35.15-0005-06
| Remove/install | ||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Notes on self-locking nuts and bolts | |||
1 | Remove the wishbone control arm screws and nuts (5) | Remove the nuts (3), screws (1) and the bushings (2) from the wishbone control arm (5). | |
Type 934, 938, 958Triangular tensioning arm | |||
Socket wrench bit | |||
2 | Remove the screws (7) from the chassis frame and extract the triangular tensioning arm (5) | Type 934, 938, 958Torsion bar (V-bar) in the frame | |
| Check | ||
3 | Check the triangular tensioning arm (5) for damage and wear | In case of signs of out-of-round and deformed lodgings, corrosion and wear: | |
| |||
Replace the wishbone control arm. | |||
4 | Check the wishbone control arm (5) bushings (2) for damage and wear | In case of deformations found in the housings or signs of excessive wear: | |
| |||
Replace the wishbone control arm bushings. | |||
5 | Remove the screws (4), then remove the support rack (6) | Only if necessary. | |
Type 934, 938, 958Rear axle bearing support | |||
6 | Installation in reverse order |
963 589 00 09 00
Socket wrench bit
Referenced documents
- ah0000n000101a Notes on self-locking nuts and bolts
- ar3515b000101b Remove/install pin for wishbone control arm
- as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.