AR35.10-P-0010MB | Removing and installing complete rear axle | 21.1.99 |
MODELS 220.175 /178
with CODE (Z04) Light armoring
with CODE (Z07) Maximum protection
P35.10-2075-09
Illustrated for code Z07
Fig. item, etc. | Work instructions | ||
| The removal of the rear axle corresponds to production vehicles except for the modifications listed below | Refer to: | |
Removing and installing complete rear axle | |||
Danger! | Risk of injury with trapped or crushed limbs when working on springs or spring-loaded components. | Use only approved tensioning devices; additionally shield off hazardous area if necessary. Check special tools for damage and correct operation, (visual inspection). Wear protective gloves. | |
73 | Rear spring | Tension on left and right, for Code Z07 only. | |
| Spring compressor | ||
| Clamping plates | ||
1c | front rear axle mount | ||
Arrow | Stop plate | Install components in correct positions. | |
1 | Rear axle | Use pit lift or floor jack under rear axle center assembly for support. The assembly adapter specified for production vehicles must not be used. | |
| Bleed brake system | for Code Z07 only Modified work procedure due to brake booster hydraulic unit | |
Check vehicle level at front and rear axle with electronic inclination meter and adjust, if necessary | for Code Z04 | ||
for Code Z07 |
202 589 13 63 00
Clamping plates
Spring compressor
202 589 01 31 00
Referenced documents
- ar3220p020006mb Clamping rear spring
- ar3510p0010i Remove/install complete rear axle
- ar4020p0301i Check vehicle level at front and rear axle with electronic inclinometer, adjust if necessary
- ar4020p0301mb Check vehicle level at front and rear axle with electronic inclinometer, adjust if necessary
- ar4210p0010mb Bleed brake system
- as0000z000101a Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under tension