ar3330p0670ff

Remove/install rubber boot on drive shaft at outboard end

Type ar · topic 33.30 · version 0100 · 2006-07-26

Applies to: MODEL 454.0

Where it sits

Function group 2 Chassis › 33 Front axle › 33.30 Final drive, differential, drive shaft — Series 454 (models 0**)

EinPAS 17 Drivetrain/axle › 17.50 Front axle › 17.50.51 Axle shaft/drive shaft — Series 454 (models 0**)

AR33.30-P-0670FF

Remove/install rubber boot on drive shaft at outboard end

17.1.06

MODEL 454.0

Remove/install rubber boot on drive shaft at outboard end

P33.30-2117-01

Shown on right-hand side of vehicle with engine 135.9

1 Boot

2 Vibration damper (on engines 134.9 and 135.9)

3 Hose clamp (on engines 134.9 and 135.9)

4 Rubber boot

5 Drive shaft

Remove/install rubber boot on drive shaft at outboard end

P33.30-2114-06

Shown on right-hand side of vehicle with engine 135.9

1 Boot

5 Drive shaft

6 Constant velocity joint

7 Hose clamp

8 Hose clamp

Remove

1

Remove rubber boot (4) from drive shaft (5) at transmission end

AR33.30-P-0680FF

2.1

Detach hose clamp (3) from vibration damper (2)

When removing the right drive shaft (5) on vehicles with engines 134.9, 135.9.

3.1

Mark position of vibration damper (2) and spray drive shaft (5) with suitable grease at transmission end

When removing the right drive shaft (5) on vehicles with engines 134.9, 135.9.

4.1

Pull vibration damper (2) off drive shaft (5)

When removing the right drive shaft (5) on vehicles with engines 134.9, 135.9.

5

Detach hose clamps (7, 8)

6

Cut open boot (1) and pull off

7

Clean constant velocity joint (6) and drive shaft (5)

Install

8

Spray drive shaft (5) with suitable grease and push new boot (1) with hose clamps (7, 8) onto drive shaft (5)

The boot (1) must not be damaged when it is pushed onto the drive shaft (5) otherwise dirt will enter the constant velocity joint (6) and cause irreparable damage.

Helper required

9

Fill boot (1) and constant velocity joint (6) with the grease included in the package

Use the grease tubes with the blue marking.

10

Align drive shaft (5) straight with constant velocity joint (6), position boot (1) on constant velocity joint (6) and fasten hose clamps (7, 8)

Ensure that the hose clamps (7, 8) are properly seated.

*WH58.30-Z-1011-02A

11

Lower drive shaft (5) downwards

12.1

Spray drive shaft (5) with suitable grease and push vibration damper (2) onto drive shaft (5) as far as the marking made during removal

When installing the right drive shaft (5) on vehicles with engines 134.9, 135.9.

13.1

Attach hose clamp (3) to vibration damper (2)

When installing the right drive shaft (5) on vehicles with engines 134.9, 135.9.

14

Install new rubber boot (4) on drive shaft (5) at transmission end

A new rubber boot (4) is included with the boot (1).

AR33.30-P-0680FF

Commercially available tools

Number

Designation

WH58.30-Z-1011-02A

Clamping pliers

Referenced documents