ar3020l1000va

Remove/install pedal value sensor

Type ar · topic 30.20 · version 0101 · 2003-03-13

Applies to: ENGINE 166, 668 in MODEL 168 ENGINE 166.961 /991, 668.914 in MODEL 414.700

Where it sits

Function group 1 Engine › 30 Throttle control, speed control systems › 30.20 Electronic accelerator (EA)/cruise control (CC)/idle speed control (ISC) — Series 166 · Series 168 · Series 414 (models 700) · Series 668

EinPAS 15 Engine › 15.45 Engine management › 15.45.12 Sensor/switch/wiring harness — Series 166 · Series 168 · Series 414 (models 700) · Series 668

AR30.20-L-1000VA

Remove/install pedal value sensor

20.7.01

ENGINE 166, 668 in MODEL 168

ENGINE 166.961 /991, 668.914 in MODEL 414.700

Remove/install pedal value sensor

L30.20-0002-06

Shown on model 414

1 Accelerator pedal

2 Link rod

3 Screws

4 Return device

5 Plug socket

B37 Pedal value sensor

Remove/install

1

Switch off ignition

2

Remove accelerator pedal (1)

Model 414

AR30.12-L-1321VA

Model 168

AR30.12-P-1321GF

3

Detach link rod (2) from return device (4) of pedal value sensor (B37)

4

Unscrew screws (3)

5

Remove pedal value sensor (B37) with return device (4) from pedal bearing bracket

Installation: attach return spring (arrow) of return device (4) to pedal bearing bracket. Twist pedal value sensor (B37) with return device (4) into position.

6

Pull out plug socket (5) from pedal value sensor (B37)

Installation: route the electric cable, open tie strap (arrow) if necessary.

7

Remove return device (4) from pedal value sensor (B37)

Installation: insert the guides on pedal value sensor (B37) into the bores on return device (4).

8

Install in the reverse order

Referenced documents