AR27.00-D-0270-01B | Top up automatic transmission after repair work or maintenance with automatic transmission fluid | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. |
Modification notes
10.2.12 | Value modified: Automatic transmission fluid ATF, Specifications for Operating Fluids | ||
Value modified: Automatic transmission fluid ATF, Specifications for Operating Fluids |
Automatic transmission
Number | Designation | Model | ||
BF27.00-N-1001-01C | Automatic transmission fluid ATF | Filling capacity, first filling | Liters | 7.8 |
Filling capacity, oil change | Liters | - | ||
Specifications for Operating Fluids | Sheet | – | ||
Sheet | ||||
Automatic transmission
Number | Designation | Transmission | |||
BF27.00-N-1001-01A | Automatic transmission fluid ATF | Filling capacity, first filling | Liters | 7,6 | |
Filling capacity, oil change | Liters | - | |||
Filling capacity, transmission oil change | with torque converter | Liters | 7.0 | ||
Filling capacity, transmission oil change | without torque converter | Liters | 5,0 | ||
Specifications for Operating Fluids | Sheet | – | |||
Sheet | |||||
Sheet | - | ||||
Sheet | - | ||||
Sheet | - | ||||
210 589 00 71 00
Funnel
Hand pump
Dipstick
140 589 15 21 00
126 589 12 63 00
P27.50-0274-06
93 Plug
93a Locking pin
A Cold measuring range
(cold automatic transmission fluid,
25 °C, 77 °F)
B Hot measuring range
(hot transmission oil, 80 °C, 176 °F)
1 Remove cap (93).
Break off locking pin plate (93a) and press out locking pin (93a) remaining in cap (93) downwards.
2 Insert funnel into opening of oil filler pipe and add the specified quantity of automatic transmission fluid.
3 Start the engine and allow to run in selector lever position "P "at idle speed for approx. 1 minute.
Apply parking brake
4 Apply service brake and shift through all gear ranges several times with vehicle stationary and engine running at idle speed
Remain in each transmission position for approx. 10 s. Afterwards shift transmission into position "P" again.
5 Check current transmission oil temperature using Diagnosis Assistance System (DAS).
6 Check transmission oil level with dipstick and correct if necessary.
Check oil level when engine is running. When the transmission is cold (approx. 25 °C) the oil level reading must be in the cold measuring range (A). With a hot transmission (approx. 80 °C), the oil level reading must be in the warm measuring range (B). Determinate for the correct transmission oil level is the hot measuring range (B) with transmission at operating temperature (70 °C to 90 °C).
It is essential to drain excess transmission oil or extract it using a handpump. When extracting attention must be paid to the utmost cleanliness of the hose and hand pump, otherwise malfunctions may occur.
7 Fit plug (93) on oil filler pipe and install new locking pin (93a).
The locking pin (93a) must lock in place.
Referenced documents
- as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.