W26.45-0068-09
1 Sliding sleeve
2 Threaded plug
3 Spring
4 Selector fork
5 Snap-ring
6 Bearing outside race
7 Taper roller bearing
8 Input shaft
9 Taper roller bearing
10 Bearing outside race
11 Compensating washer
12 Sealing ring
13 Pressure pin
14 Cylinder gasket
15 Shifting cylinder
16 Cylinder bolt
17 Snap-ring
18 Bearing outside race
19 Taper roller bearing
20 Main shaft (version NA121-2c)
21 Main shaft (version NA121-2b)
22 Taper roller bearing
23 Bearing outside race
24 Compensating washer
S23 Power take-off switch
| Disassemble | ||
1 | Remove the power take-off | ||
2 | Remove the output flange and the cover | On version 2b | |
3 | Remove the shifting cylinder (15) | ||
4 | Remove the selector fork (4) and the sliding sleeve (1) | ||
5 | Remove the snap-ring (5) | ||
| The taper roller bearings of the input and output shafts are equal. Therefore, it is necessary to always pay attention in order not to swap the races. | ||
Danger! | Risk of injury on skin and eyes from handling hot or incandescent objects | Use protection gloves, clothes and goggles | |
6 | Remove the input shaft (8) | To facilitate the assembly, heat the body up to approximately 80 -100 °C. | |
7 | Check the taper roller bearings (7) and (9) of the input shaft (8) for condition, if necessary, remove them utilizing an appropriate tool | ||
8 | Remove the outside race of the bearing (10) and the compensating washer (11) | Inside claw puller | |
Counter-support | |||
9 | Remove the snap-ring (17) | ||
Danger! | Risk of injury on skin and eyes from handling hot or incandescent objects | Use protection gloves, clothes and goggles | |
10.1 | Remove the main shaft (20) | To facilitate the assembly, heat the body up to approximately 80 -100 °C. In version 2c. | |
10.2 | Remove the main shaft (21) | On version 2b. | |
Impact puller | |||
Threaded pin | |||
11 | Check the taper roller bearings (19) and (22) of the main shaft (2021) for condition, if necessary, remove them utilizing an appropriate tool | ||
12 | Remove the outside race of the bearing (23) and the compensating washer (24) | Inside claw puller | |
Counter-support |
000 589 29 33 00
Inside claw puller
000 589 34 33 00
Counter-support
355 589 01 63 00
Impact puller
385 589 01 63 00
Threaded pin
Referenced documents
- ar2645b0001e Remove/install PTO
- ar2645b0011c Remove/install radial shaft seal for output flange
- ar2645b0020d Remove/install shift cylinder
- ar2645b0036a Remove/install power take-off shift fork
- as0000b000201a Risk of injury. Skin or eye injuries may result when handling hot or glowing objects.