Remove/install right engine support

AR22.10-P-4340RT

Remove/install right engine support

15.2.12

28.3.07

Bolt, engine support to cylinder crankcase, 1st stage

*BA22.10-P-1003-01S

 

Remove/install

 Danger!

Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof.

Keep body parts and limbs well clear of moving parts.

AS00.00-Z-0011-01A

 Danger!

Risk of death caused by vehicle slipping or toppling off the lifting platform.

Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer.

AS00.00-Z-0010-01A

 Danger!

Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices

No fire, sparks, open flames or smoking.

Wear acid-resistant gloves and clothing and safety glasses with side guards.

Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground.

Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers.

AS54.10-Z-0001-01A



Notes on battery

All models

AH54.10-P-0001-01A



Notes on self-locking nuts and bolts

All models

AH00.00-N-0001-01A

1

Open engine hood

AR88.40-P-1000RT

2

Disconnect ground line from battery

 Only when removing the engine mount on the right side.

AR54.10-P-0003RT

3

Raise vehicle with lifting platform

AR00.60-P-1000RT

4

Dismantle engine mount at right engine support (1).

AR22.10-P-1100RT



*BA22.10-P-1001-03F



*BA22.10-P-1002-03F

 Tool kit

*000589109900

 Connection piece

*210589001600

 Four-point drive

*210589011600

5

Remove bolt (2) and take off engine support (1)

 Installation: Bolts must be replaced, because the connection can loosen or screws can tear off if reused.



*BA22.10-P-1003-01S

6

Take out engine support (1)

7

Install in the reverse order

8

Perform basic programming

AR00.19-P-0200RT

Number

Designation

Engine
113.971
in model 251

BA22.10-P-1003-01S

Bolt, engine support to crankcase

Stage 1

Nm

20

Stage 2

°

90

Number

Designation

Model 251

BA22.10-P-1001-03F

Bolt, front engine mount to front axle carrier

Nm

53

BA22.10-P-1002-03F

Bolt, front engine mount to engine support

Nm

53