1 | Pump unit |
2 | Screws |
3 | Bracket |
4 | Screws |
5 | Switchover valve |
6 | Electrical wiring harness |
7 | Screws |
8 | Vacuum line |
9 | Screws |
P20.10-2509-12
Warning | Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. | |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
| Remove/install | ||
1 | Drain off coolant. | ||
2 | Remove poly-V-belt. | ||
3 | Unclip switchover valve (5) from bracket (3). | ||
4 | Remove screws (2, 4) and remove bracket (3). | Screw, diesel particulate filter bracket to timing case | |
Bolt, diesel particulate filter bracket to crankcase | |||
5 | Remove screws (7) of the electrical wiring harness (6) from the crankcase. | ||
6 | Remove vacuum line (8) from pump unit (1). | ||
7 | Remove screws (9). | Screw, bearing housing/belt pulley to water pump | |
8 | Remove pump unit (1) and catch escaping coolant using a suitable container. | Installation: Replace seal. | |
9 | Clean sealing surfaces with a lint-free rag. | ||
10 | Install in the reverse order. |
Referenced documents
- ah0000p500001a Notes on avoiding damage through contamination and foreign objects
- ar1322p1202oid Remove/install poly-V belt
- ar2000p1142oid Drain/pour in coolant
- as0000z000201a Risk of injury. Skin or eye injuries may result when handling hot or glowing objects.
- as2000z000101a Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant.