ar1510s2000se

Remove/install camshaft Hall sensor

Type ar · topic 15.10 · version 0200 · 2010-08-19

Applies to: ENGINES 642 in MODEL 639

Where it sits

Function group 1 Engine › 15 Electrical system - engine › 15.10 Ignition system, general — Series 639

EinPAS 15 Engine › 15.17 Engine timing › 15.17.12 Sensor/switch/wiring harness — Series 639

Also applies to engines/gearboxes: 642 ***

AR15.10-S-2000SE

Remove/install camshaft Hall sensor

16.8.10

ENGINES 642 in MODEL 639

Remove/install camshaft Hall sensor

S15.10-4502-11

B6/1 Hall sensor for camshaft

Modification notes

10.5.10

Reference to be added

Operation step 3

 	Remove/install
1	Remove engine trim panel		AR01.10-S-2405SE
2	Remove engine air intake duct downstream of air filter		AR09.10-S-8130SE
3	Remove trim panel on right cylinder head cover		AR01.20-D-5015SF
4	Disconnect electrical connector on camshaft Hall sensor (B6/1)
5	Remove camshaft Hall sensor (B6/1)	 To do this, undo bolt.
		 Installation: Replace sealing ring.
			*BA15.10-N-1002-03B
6	Install in the reverse order
	Checking
 Danger!	Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running	Secure vehicle to prevent it from moving by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.	AS00.00-Z-0005-01A
7	Check for leaks with engine running	 Visual inspection only.

 Hall sensor

Number	Designation			Engine 642


BA15.10-N-1002-03B	Camshaft position sensor at cylinder head cover		Nm	8

Referenced documents

ar0110s2405se Remove/install engine cover
ar0120d5015sf Remove/install cylinder head cover trim panel
ar0910s8130se Remove/install engine intake air duct downstream of air filter
as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.