AR15.10-P-2000M | Remove/install camshaft Hall sensor | 16.8.06 |
ENGINE 275 in MODEL 215, 216, 220, 221, 230
P15.10-2107-12
Illustrated on model 220
1 Charge air cooler
B6/2 Camshaft Hall sensor, left cylinder bank
B6/3 Camshaft Hall sensor, right cylinder bank
| Remove/install | ||
Danger! | Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof. | Keep body parts and limbs well clear of moving parts. | |
1 | Remove right charge air cooler (1) from engine and connect with connected coolant hoses to the engine hood | Do not open low temperature circuit. | |
2 | Pull out the plug (arrow) | ||
3 | Remove camshaft Hall sensor, left cylinder bank (B6/2) and camshaft Hall sensor, right cylinder bank (B6/3) | Installation: Check sealing ring; replace if necessary. | |
| |||
4 | Install in the reverse order | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
5 | Run engine and inspect for oil leaks | ||
6 | Read out fault memory and erase if required | | |
| Connect STAR DIAGNOSIS and read out fault memory |
Position sensor
Number | Designation | Engine | |
BA15.10-P-1002-03D | Camshaft position sensor to cylinder head cover | Nm | 8 |
Commercially available tools
Referenced documents
- ad0000p200004a Connect STAR DIAGNOSIS and read out fault memory
- ad0000p200004a
- ar0941p6817hh Remove/install charge air cooler
- as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.