AR14.40-B-2039B | Attach/remove test facility for checking the AdBlue metering amount on metering device | 12.02.16 |
Cumbustion engine 457.9 with Vehicle 382.15# #D, 634.0## #D with CODE MS5 (BlueTec 5)
W14.40-1369-06
1 Testing injection pipe
2 Testing injection nozzle
4 Hose
5 Bottle
6 Wire clamp
Installing | |||
Danger! | Risk of burns and scalding while working on AdBlue pipes and components connected to them. Risk of injury on skin and eyes at contact with AdBlue. Risk of poisoning from swallowing AdBlue | Only catch AdBlue in appropriate containers. Only start working on the exhaust gas after-treatment system after relieving the pressure. | |
| Indications for applications, material properties and handling AdBlue | ||
1 | Open the engine compartment access cover | Access to carry out maintenance and repair services, varies according to body type/make. Refer to body maker instructions. | |
2 | Cover the starter with a clean rag | Before removing the injection pipe, the starter has to be covered with a clean rag to protect it from eventual AdBlue sprinkles, as they could damage the starter and the connected electric wiring harnesses. | |
3 | Remove the injection pipe | ||
4 | Install the AdBlue dosage volume testing device | ||
| AdBlue dosage volume testing device of the metering unit | ||
5 | Install the test injection pipe (1) with the test injection nozzle (2) in the metering unit | ||
6 | Connect the hose (4) on the test injection nozzle (2) and fasten with a plastic clamp (6) | ||
7 | Place the plastic bottle (5) on the floor | Be sure the hose (4) is not folded. The test is carried out with the help of the STAR DIAGNOSIS. | |
REMOVAL | |||
8 | Remove the testing device from the metering unit | After using, clean the device with clean water. | |
9 | Install a new injection line | The injection pipe has to be replaced whenever removed. |
Referenced documents
- ah1440b000101a Notes on use, material properties and handling of AdBlue®
- ar1440b2001b Remove/install injection line for exhaust aftertreatment system
- as1440b000101a Risk of burn injuries and scalding when working at AdBlue lines and the components attached to them. Risk of injury to skin and eyes when handling AdBlue. Risk of poisoning caused by swallowing AdBlue
- wf5850b144004a Test facility for checking the AdBlue metering mount of the metering device