ar0941g2003na

Remove/install boost pressure/charge air temperature sensor

Type ar · topic 09.41 · version 0105 · 2019-05-13

Applies to: Engine 902.912 in model 405.210/230 For USA/Canada only Engine 906.936 in model 405.210/230 For USA/Canada only Engine 906.967 in model 405.210/230 with code M03 (Increased engine output) For USA/Canada only

Where it sits

Function group 1 Engine › 09 Air intake, turbocharging › 09.41 Charge air pipe/charge air cooling — Series 405 (models 210, 230) · Series 902 (models 912) · Series 906 (models 936, 967)

EinPAS 15 Engine › 15.30 Air intake/charging › 15.30.12 Sensor/switch/wiring harness — Series 405 (models 210, 230) · Series 902 (models 912) · Series 906 (models 936, 967)

AR09.41-G-2003NA

Remove/install boost pressure/charge air temperature sensor

23.04.2019

Engine

902.912 in model 405.210/230

For USA/Canada only

Engine

906.936 in model 405.210/230

For USA/Canada only

Engine

906.967 in model 405.210/230

with code M03 (Increased engine output)

For USA/Canada only

Remove/install boost pressure/charge air temperature sensor

Shown on engine 906

1

Cap

2

Connector for engine wiring harness

3

Boost pressure and charge air temperature combination sensor

W09.41-1001-11

Remove/install

Warning

Risk of injury caused by body parts being pinched or crushed as cab is tilted

Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure it with the safety strut.

AS60.80-Z-0001-01A

1

Tilt cab

AR60.80-G-0010NA

Topical note

Notes on tilting the cab

AH60.80-N-0003-01B

2

Remove cover cap (1) from charge air manifold

Engine 906

3

Disconnect engine wiring harness connector plug (2) from boost pressure and charge air temperature combination sensor (3)

4

Remove boost pressure and charge air temperature combination sensor (3)

Installation: Check O-ring for wear and damage; replace if necessary.

Screw, charge air pressure and temperature sensor to charge air distributor

*BA09.41-N-1008-01J

5

Install in the reverse order

Charge air pipe/charge air cooling

Number

Designation

Engine 902.912, 906.936/967

BA09.41-N-1008-01J

Screw, charge air pressure and temperature sensor to charge air distributor

Nm

10

Referenced documents