Remove/install throttle valve actuator

AR07.61-P-1401RT

Remove/install throttle valve actuator

3.9.08

11.8.08

Perform default initialization - added

Step 9

 

Remove/install

 Danger!

Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof

Keep body parts and limbs well clear of moving parts.

AS00.00-Z-0011-01A

1

Open engine hood and raise to vertical position

AR88.40-P-1000RT

2

Remove partition wall between wheel wells

AR62.30-P-2400RT

3

Remove air filter housing

AR09.10-P-1150RT

4

Remove hot film mass air flow sensor (B2/5)

AR07.07-P-1454RT

5

Disconnect electrical connector in feed line throttle valve actuator (M16/6)

 Do not disconnect plug on throttle valve actuator (M16/6) since it is bonded. The electrical connections on throttle valve actuator (M16/6) and on air recirculation flap actuator are identical and can be interchanged. The wiring harness on throttle valve actuator (M16/6) is marked with a blue insulation tape. If this is not the case, mark wiring harness before disconnecting electrical connector.

 Installation: Coat electrical connector with contact fluid.

Contact fluid

*BR00.45-Z-1001-14A

6

Remove bolts (1) of throttle valve actuator (M16/6)



*BA07.61-P-1001-01A

7

Remove throttle valve actuator (M16/6)

 Installation: Install new gasket

8

Install in the reverse order

9

Perform default initialization

After throttle valve actuator valve is replaced (M16/6).

 Connect STAR-DIAGNOSIS and select menu item for control unit adaptations in ME control unit.



Connect STAR DIAGNOSIS and read out fault memory

AD00.00-P-2000-04A

10

Read out fault memory and erase if necessary

Number

Designation

Engines
112, 113

BA07.61-P-1001-01A

Bolt on throttle valve actuator

Nm

10

Number

Designation

Order number

BR00.45-Z-1001-14A

Contact fluid

A 008 989 55 71