ar0910p1150rt

Remove/install air filter housing

Type ar · topic 09.10 · version 0100 · 2005-07-14

Applies to: ENGINE 113.971 in MODEL 251.075 /175

Where it sits

Function group 1 Engine › 09 Air intake, turbocharging › 09.10 Air cleaner — Series 251 (models 075, 175)

EinPAS 15 Engine › 15.30 Air intake/charging › 15.30.40 Air filter/air filter box — Series 251 (models 075, 175)

Also applies to engines/gearboxes: 113 971

AR09.10-P-1150RT

Remove/install air filter housing

6.6.05

ENGINE 113.971 in MODEL 251.075 /175

Remove/install air filter housing

P09.10-2165-04

1 Partition wall

2 Air filter housing

3 Intake air duct

4 Engine cover

5 Supports

6 Supports

 	Remove/install
 Danger!	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	When moving components, ensure that no body parts or limbs are within the operating range of moving parts.	AS00.00-Z-0011-01A
1	Open engine hood		AR88.40-P-1000RT
2	Remove engine trim panel (4)		AR01.10-P-2405RT
3	Remove the left and the right intake air duct (3)
4	Remove partition (1)		AR62.30-P-2400RT
5	Detach the air filter housing (2) from the mounts (5, 6) at the left and right cylinder head cover from above	 In order to avoid scratches and damage, the air filter housing (2) must be put down on a padded base.
6	Install in the reverse order

Referenced documents

ar0110p2405rt Remove/install engine cover
ar0110p2405rtb Remove/install engine cover
ar6230p2400rt Remove/install partition wall between wheelhouses
ar8840p1000rt Opening engine hood, moving to upright position and closing
as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.