ar0752d1466we

Remove/install charge air temperature sensor

Type ar · topic 07.52 · version 0101 · 2011-06-07

Applies to: ENGINES 651 in MODEL 900 ENGINES 651.955 /956 /957 in MODEL 906

Where it sits

Function group 1 Engine › 07 Mixture formation › 07.52 PEC-SFI fuel injection/ignition system — Series 651 · Series 900 · Series 906

EinPAS 15 Engine › 15.30 Air intake/charging › 15.30.12 Sensor/switch/wiring harness — Series 651 · Series 900 · Series 906

AR07.52-D-1466WE

Remove/install charge air temperature sensor

23.5.11

ENGINES 651 in MODEL 900

ENGINES 651.955 /956 /957 in MODEL 906

Remove/install charge air temperature sensor

D07.52-0025-04

1 Electrical connector

2 Charge air duct

B17/13 Charge air temperature sensor

 	Remove/install
1	Lift/jack up vehicle		AR00.60-D-1000H
2	Disconnect electrical connector (1) at charge air temperature sensor (B17/13)
3	Unclip charge air temperature sensor (B17/13) on charge air duct (2) (arrows) and remove	 Installation: Install new sealing ring.
4	Install in the reverse order
 Danger!	Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running	Secure vehicle to prevent it from moving by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.	AS00.00-Z-0005-01A
5	Perform engine test run and check engine in the area of the charge air temperature sensor (B17/13) for leaks

Referenced documents

ar0060d1000h Lift/jack up vehicle
as0000z000501a Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.