W07.16-1234-09
1 | Fuel system high pressure pump | 4 | Screw | 8 | Nut | ||
2 | Drive gear | 5 | Positioning disk | 9 | Two-armed puller | ||
3 | Locating tool | 6 | Driver | Pfeil | Marking | ||
3.1 | Adapter (from the scope of the locating tool) | 7 | Roll pin |
Caution | Risk of injury to skin and eyes due to handling of engine oil. Risk of poisoning caused by swallowing engine oil | Wear protective gloves, protective clothing and safety glasses. | |
Danger | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel. | No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only. | |
Topical note | Notes on self-locking nuts and bolts | ||
| Remove/install | ||
1 | Remove fuel system high pressure pump (1) | ||
2 | Attach a suitable adapter (3.1) for the drive gear (2) to the locating tool (3) | Locating tool | |
3 | Attach fuel system high pressure pump (1) to the locating tool (3) | Locating tool | |
4 | Remove drive plate (6) | Installation: Replace screws/bolts (4). Wet toothing of the driver (6) slightly with engine oil. | |
Screw, driver to drive wheel for fuel high-pressure pump | |||
5 | Remove positioning disk (5) from drive gear (2) | Installation: The marking (arrow) on the positioning disk (5) must point away from the fuel system high pressure pump (1). | |
6 | Unfasten nut (8) | Nut, drive wheel to fuel high-pressure pump | |
7 | Detach drive gear (2), | Puller, two-arm | |
8 | Unscrew nut (8) | ||
9 | Remove drive gear (2) | Installation: The cone of the drive shaft and the tapered seat of the drive gear (2) must be free of grease. | |
10 | Check roll pin (7) for damage; replace if necessary | ||
11 | Check drive gear (2) for damage | If the drive gear (2) is damaged: | |
| |||
Replace drive gear (2). The counter gear of the gearwheel drive must also be checked for damage and replaced if necessary. | |||
12 | Install in the reverse order |
000 589 88 33 00
Puller, two-arm
470 589 08 40 00
Locating tool
Referenced documents
- ah0000n000101a Notes on self-locking nuts and bolts
- ar0716w1005ha Remove/install high-pressure fuel pump
- as1800z000101a Risk of injury to skin and eyes due to handling of engine oil. Risk of poisoning caused by swallowing engine oil
- as4700z000101a Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel.