ar0704p2000olf

Remove/install low-pressure fuel pressure sensor

Type ar · topic 07.04 · version 0101 · 2016-12-13

Applies to: Engine 651 in model 222

Where it sits

Function group 1 Engine › 07 Mixture formation › 07.04 Sender, Feeler, Sensors — Series 222 · Series 651

EinPAS 15 Engine › 15.45 Engine management › 15.45.12 Sensor/switch/wiring harness — Series 222 · Series 651

AR07.04-P-2000OLF

Remove/install low-pressure fuel pressure sensor

08.12.2016

Engine

651 in model 222

Remove/install low-pressure fuel pressure sensor

1

Electrical connector

2

Clip

3

Screw

B4/7

Fuel pressure sensor

P07.04-2797-06

Danger !

Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel.

No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only.
Wear protective clothing when handling fuel.

AS47.00-Z-0001-01A

Remove/install

1

Switch off ignition and remove transmitter key

2

Remove vacuum reservoir

AR07.09-P-0001OLF

3

Detach exhaust gas recirculation cooler, swivel with attached coolant lines upwards and fix in place

4

Disconnect the electrical connection (1) on the fuel pressure sensor (B4/7)

Installation: Ensure that electrical connection (1) is correctly engaged on the fuel pressure sensor (B4/7).

5

Unfasten clamp (2) and detach fuel hose from fuel pressure sensor (B4/7)

Installation: Replace clamp (2).

6

Remove screw/bolt (3) and take off fuel pressure sensor (B4/7)

Screw/bolt, water outlet to charge air distributor

*BA20.10-P-1006-01X

7

Install in the reverse order

8

Connect diagnostic system, read out fault memory and delete if necessary

AD00.00-P-2000-04B

Check

Danger !

Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.

Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts.

AS00.00-Z-0005-01A

9

Carry out an engine test run and check fuel system for leaktightness

Coolant pump, coolant thermostat

Number

Designation

Engine 651

BA20.10-P-1006-01X

Screw/bolt, water outlet to charge air distributor

Nm

9

Referenced documents