654 589 00 33 00
Rivet press tool
All individual tools that are listed in the repair description are part of the rivet press tool.
1 | Align gauge (L) in position 2 (P2) and tighten. |
Ensure that the alignment of the gauge (L) and timing chain is correct. |
Positions (P2) of the gauge (L) must match the holes on the cylinder head. |
A tip of the tooth of the sprocket (11) (arrow) must match the semi-circular cutout of the gauge (L) in the center at the top. |
P05.10-2609-12
2 | Turn back spindle (3) slightly. |
3 | Attach assembly guide (1d) with the semi-circular cutout for the assembly link (12) to the rivet press tool (1) and tighten with a screw. |
4 | Insert assembly pin (1e) in rivet press tool (1) from front to rear. |
5 | Insert shackle (13) into the thrust piece (1c). |
6 | Turn thrust piece (1c) so that the shackle (13) touches the bolts of the assembly link (12). |
The thrust piece (1c) must engage on the head of the assembly pin (1e). |
7 | Connect the timing chain(10) to the assembly link(12). |
P05.10-2611-06
8 | Attach rivet press tool (1) to the cylinder head and tighten with screws (1s). |
9 | Screw in spindle (3) until the push plate (1g) makes contact with the spacer sleeves (1h). |
The shackle is pressed on in the process. |
10 | Turn the spindle (3) back somewhat and remove the rivet press tool (1) from the cylinder head. |
P05.10-2614-05
11 | Align gauge (L) in position 1 (P1) and tighten. |
Ensure that the alignment of the gauge (L) and timing chain is correct. |
The positions (P1) of the gauge (L) must match the bores on the cylinder head. |
The bolt (arrow) must match the semi-circular cutout of the gauge (L) in the center at the top. |
Leave the assembly pin (1e) inserted. |
P05.10-2608-12
12 | Remove assembly guide with end-to-end hole and attach assembly guide (1f) with non-continuous hole to the rivet press tool (1) and tighten rivet press tool (1) with screw. |
13 | Align the thrust piece (1c) so that the V-shaped recess for riveting meets the bolt (arrow) of the assembly link (12). |
Thrust piece (1c) locks in place on the head of the assembly pin (1e). |
P05.10-2612-06
14 | Attach rivet press tool (1) to the cylinder head and tighten with screws (1s). |
15 | Screw in spindle (3) up to the end stop. |
At the same time, the first bolt is riveted. |
16 | Turn the spindle (3) back somewhat and remove the rivet press tool (1) from the cylinder head. |
17 | Repeat process for the second unpressed bolt as of operation step 11. |
P05.10-2614-05