ar0500p2011td

Remove/install hydraulic valve clearance compensation elements

Type ar · topic 05.00 · version 0100 · 2006-07-26

Applies to: ENGINE 628.961 in MODEL 211.028

Where it sits

Function group 1 Engine › 05 Engine timing › 05.00 General — Series 211 (models 028) · Series 628 (models 961)

EinPAS 15 Engine › 15.17 Engine timing › 15.17.30 Valve train — Series 211 (models 028) · Series 628 (models 961)

AR05.00-P-2011TD

Remove/install hydraulic valve clearance compensation elements

20.5.03

ENGINE 628.961 in MODEL 211.028

Remove/install hydraulic valve clearance compensation elements

P05.00-2042-11

Shown at left cylinder head

1 Compensating element

Remove/install

1

Open engine hood and raise to vertical position

Only close engine hood after leaktightness inspection.

AR88.40-P-1000T

2

Remove camshafts

AR05.20-P-6992TD

3

Pull out compensation element (1)

The compensation elements can also be removed with the camshaft housing. A lug prevents the compensation elements from dropping out.

Installation:Reinstall compensation elements which have not been replaced at the same place.Oil compensation elements.

Do not use a magnet!

The friction surface of the compensating element would otherwise be magnetized. This may cause minute iron swarf to gather which can result in damage to the compensating element and cam.

*WH58.30-Z-1041-02A

4

Install in the reverse order

Danger!

Risk of accident as vehicle may start off by itself with the engine running. Risk of injury as working around the engine during start-up or while running may result in contusions and burns

Secure vehicle to prevent it from moving.
Wear closed and snug-fitting work clothes.
Do not grasp hot or rotating parts.

AS00.00-Z-0005-01A

5

Run engine and inspect for oil leaks

Commercially available tools

Number

Designation

WH58.30-Z-1041-02A

Rubber suction cup, dia. 30 mm

Referenced documents